EUROM Force 1801 Mode D'emploi page 42

Operation
WARNING
Before operating, see section Safety.
WARNING
Operating the device more than 2 minutes without water leads to damage of
the high-pressure pump. If the appliance does not build up pressure within 2
minutes, switch the appliance off and proceed in accordance with the
instructions in Chapter "Troubleshooting".
CAUTION
If the lever of the jet gun is released, the pressure switch turns off the pump
and the high-pressure jet stops. The pump switches on again when the lever is
pressed.
Start
1. Make sure the ON(I)/OFF(0) switch is in the OFF(0) position (Figure 4, pos. 12).
2. Open the external water supply completely.
3. Unlock the safety lock under the trigger (Figure 6, pos. 1).
4. Squeeze the trigger (Figure 6, pos. 2) for several seconds to remove the air from the
hose.
5. Switch the device on (Figure 4, pos. 12).
Cleaning
WARNING
Be aware of the kickback when squeezing the trigger.
CAUTION
When you stop temporary:
•
•
•
1. Hold the jet gun (Figure 5, pos. 7) with both hands.
2. Aim the jet gun at the object that needs to be cleaned.
3. Squeeze the trigger (Figure 6, pos. 2) and start cleaning.
Cleaning with floor cleaner
1. Hold the jet gun (Figure 5, pos. 7) with both hands.
2. Place the floor cleaner (Figure 5, pos. 2) on the surface the be cleaned.
3. Squeeze the trigger (Figure 6, pos. 2) and start cleaning.
42
turn the device off;
close the external water connection;
remove the power plug.