Publicité
STEERING HEAD INSPECTION AND ADJUSTMENT
Check the steering stem by turning it lock
G
to lock. If there is any binding, remove the
steering stem assembly and inspect the
steering bearings.
Install the upper bracket 5, washer, steer-
G
ing stem nut 6, handlebar 7, handlebar
upper holder 8 and number plate 9.
NOTE:
5PA30760
The upper handlebar holder should be
G
installed with the punched mark a for-
ward.
Insert the end of fuel breather hose 0 into
G
the hole of the steering stem.
CAUTION:
First tighten the bolts on the front side of
the handlebar holder, and then tighten
the bolts on the rear side.
3 - 34
INSP
ADJ
Steering stem nut:
125 Nm (12.5 m • kg, 90 ft • lb)
Handlebar upper holder:
27 Nm (2.7 m • kg, 19 ft • lb)
Pinch bolt (upper bracket):
22 Nm (2.2 m • kg, 16 ft • lb)
Number plate:
7 Nm (0.7 m • kg, 5.1 ft • lb)
Publicité
