Publicité
FRONT BRAKE PAD INSPECTION AND REPLACEMENT
È
REAR BRAKE ADJUSTMENT/
5PA30330
5PA30340
É
5PA30350
5PA30360
EC364002
REAR BRAKE ADJUSTMENT
1. Check:
Brake pedal height a
G
Out of specification → Adjust.
Brake pedal height a:
4 ~ 10 mm (0.16 ~ 0.39 in)
2. Adjust:
Brake pedal height
G
Pedal height adjustment steps:
Loosen the locknut 1.
G
Turn the adjusting nut 2 until the pedal
G
height a is within specified height.
Tighten the locknut.
G
WARNING
Adjust the pedal height between the
G
maximum È and the minimum É as
shown. (In this adjustment the bolt 3
end b should protrude out of the lower
adjusting nut 4 but not be less than
2 mm (0.08 in) c away from the brake
pedal 5).
After the pedal height adjustment, make
G
sure that the rear brake does not drag.
FRONT BRAKE PAD INSPECTION AND
REPLACEMENT
1. Remove:
Rubber cap
G
2. Inspect:
Brake pad thickness a
G
Out of limit → Replace as a set.
Brake pad thickness:
4.0 mm (0.16 in)
<Limit>: 0.8 mm (0.03 in)
3 - 18
INSP
ADJ
Publicité
