Publicité
REAR BRAKE PAD INSPECTION AND REPLACEMENT
REAR BRAKE PAD INSPECTION AND
REPLACEMENT
1. Inspect:
Brake pad thickness a
G
Out of limit → Replace as a set.
5PA30410
2. Replace:
Brake pad
G
Brake pad replacement steps:
Loosen the pad pins 1 and remove the
G
brake caliper 2.
NOTE:
Before removing the brake caliper from the
swingarm, loosen the pad pins.
5PA30420
Remove the pad pins 3 and brake pads
G
4.
Connect the transparent hose 5 to the
G
bleed screw 6 and place the suitable con-
tainer under its end.
Loosen the bleed screw and push the
G
brake caliper piston in.
CAUTION:
Do not reuse the drained brake fluid.
5PA30430
Tighten the bleed screw.
G
Install the brake pads 7 and pad pins 8.
G
NOTE:
Install the brake pad fitted with the brake
pad shim 9 on the brake caliper piston side.
5PA30440
5PA30450
3 - 20
INSP
ADJ
Brake pad thickness:
3.7 mm (0.15 in)
<Limit>: 1.0 mm (0.04 in)
Bleed screw:
6 Nm (0.6 m • kg, 4.3 ft • lb)
Publicité
