Conti CC200 DISPLAY Notice Technique page 43

23.2. HOT WATER DOSE PROGRAMMING
«Hot water» key
Methodology:
One programming dose is available:

Press key n°5 (MENU) from the 1st group during 5 seconds.

Display shows « Press dose selection within 30s ».

Push hot water key to start the flow, and push again when the water volume is correct.

You can use hot water key after the message «Press dose selection within 30s» disappears.
Edition 06/2019 - CC200 Display - TECHNICAL DOCUMENTS - page 42
SACOME, CONFIDENTIAL Document,
it is forbidden to duplicate or communicate this document without previous authorization.