Conti CC200 DISPLAY Notice Technique page 37

20. INSTALLATION
20.1. IN CASE OF A STANDBY OF THE MACHINE (STANDBY = 2 MONTHS):

The first thing to do is to test your machine in a lab.

If the machine stop ruming for a long time, you could have scale in some places.

More precisely in small area like the spray nozzle.
20.2. PROTECTIONS

It is necessary to place before the machine:
o A water shutoff valve.
o An electrical protection standard, suitable for voltage and power consumption.
20.3. WATER SUPPLY

Recommended operating pressure from 0,15 MPa to 0,6 MPa

Water connection pin 3/8"

The water supply pipes must resist to 145 Psi / 1 MPa
20.4. DRAIN

Without pressure.

Spigot at the outlet of the machine and a pipe is supplied with the machine

Ensure a connection that causes no risk of fluid return, and ensure good drainage:


20.5. SUPPLYING VOLTAGE
According to the model:
 230V – 50/60Hz Monofase
400V – 50/60Hz Trifase

Edition 06/2019 - CC200 Display - TECHNICAL DOCUMENTS - page 36
SACOME, CONFIDENTIAL Document,
The drain pipe must be located lower than the machine.
Do not create a bend in the exhaust tube.
it is forbidden to duplicate or communicate this document without previous authorization.