Conti CC200 DISPLAY Notice Technique page 39

21. OPERATION
21.1. RECOMMANDATIONS
 Open the general water tap, if it is closed, then open the water shutoff valve dedicated to
the machine.
 Do not put the supplying voltage at this moment.
 Verify the presence of water, by reading the pressure of the mains water inlet on the M2
manometer pump.
21.2. INITIAL FILLING
 Ensure that steam taps operating levers 'V' are open (up).
 Put the ON/OFF switch 'C' to position 1 (power on).
 The key board turn on.
 The boiler fills automatically, without heating.
 The machine start to heat automatically, only when the level probe is reached by the water
 A scrolling LED on keypads can inform the user about the status. (info display :« machine
en chauffe »)
 Close the steam tap "V" and wait.
 When the scrolling leds stops : The machine is ready to operate
(info display : « < 60°C CONTI ESPRESSO »)
21.3.

Further fillings will run automatically, according to the hot water needs.

The water level in the boiler is controlled by the electronics, by the means of a level
probe.
Edition 06/2019 - CC200 Display - TECHNICAL DOCUMENTS - page 38
SACOME, CONFIDENTIAL Document,
FURTHER FILLINGS
it is forbidden to duplicate or communicate this document without previous authorization.