Conti CC200 DISPLAY Notice Technique page 36

19. CAUTION DURING THE USE
19.1. AMBIENT CONDITIONS

The ambient temperature around the machine had to be between 5°C et 32°C.

The ambient humidity must not exceed 70 %

The machine must be placed such as the cup warmer is located more than 1.5 meters
from the ground.
19.2. DURING INSTALLATION

The installation (electrical connections, water supply and drainage) must be carried out
by a qualified technician approved by CONTI.

The machine must be connected to a device conforming to the standards of the country
where the machine is installed. Potential costs of equipment compliance are the only
responsibility of the customer.

For any technical intervention, the machines must always have the power disconnected
from the mains.

An effective earth connected to the terminal provided for this purpose on the device is
mandatory

A screw located under the bottom base machine, allow if necessary, to connect several
machine on an equipotential way.

Devices for disconnection from the main supply, having a contact separation of at least
3mm in all poles, must be provided in the fixed wiring in accordance with the installation
rules.
19.3. DURING THE USE

When the machine is not operating, the water cut-off valve has to be closed and the
electrical power supply cut.

When the machine is not supervised it must be disconnected from the power and water
supply.

Never disconnect the earthing when the machine is connected to the power supply.

Machines must always be disconnected from the main power, in case of technical
interventions.

We guarantee our machines subject to a correctly sized water treatment is installed
backward and adjusted according to the carbonate hardness of the water network.
19.4. RULES RELATING TO THE ENVIRONMENT

This device has been designed according to the European Directive No. 2002/95/EC.
This refers to the restriction of certain hazardous substances in electrical and electronic
equipment (ROHS)

This device has been designed in compliance with the European Directive No.
2002/96/EC concerning waste electrical equipment (WEEE).

This picture informs you that this device should not be discarded with household waste.

At end of life, this product must be returned to a collection point or returned to an
authorized dealer. By doing so, you will help to protect the environment and human
health.
Edition 06/2019 - CC200 Display - TECHNICAL DOCUMENTS - page 35
SACOME, CONFIDENTIAL Document,
it is forbidden to duplicate or communicate this document without previous authorization.