Publicité
Les langues disponibles
Les langues disponibles
Keep the packaging for at least the duration of the warranty period, for any shipments to the after-sales
centre for repairs. Dispose of packaging in compliance with the regulations in force regarding waste disposal.
2 - INSTALLATION
2.1 - INSTRUCTIONS FOR INSTALLATION
To obtain the best results and optimum performance, follow the instructions for correct installation provided
in this manual.
A failure to implement the indicated standards, which may cause a malfunction
of the appliances, relieves OLIMPIA SPLENDID from any form of warranty and
from any liability for possible damages caused to people, animals or things.
The electrical system must be compliant with legal standards, must respect
the data in the technical data sheet and be must be equipped with an efficient
ground system.
The appliance shall be installed in such a position that maintenance can be
carried out easily.
2.2 - INSTALLATION OF THE INTERNAL UNIT
Prepare:
•
Four dowels with a diameter of 10 mm for wall fixing suitable for the type of support.
•
A lateral and upper free space of at least 25 cm, sufficient to allow for the removal of the covers for
ordinary and extraordinary maintenance operations.
•
A nearby water drain.
•
A compliant power supply, near the internal unit.
•
A water supply for filling of the hydraulic circuit.
•
Communication cable between internal and external unit (see par.3.6.2).
Refer to "Fig.5" for the position of the pipes.
The internal unit must be fixed to the wall at head height inside the residence.
Refer to "Fig.5" for installation spaces.
•
Connect the wire way (X) for condensation drain to the hole positioned in
the rear part of the tray and make it come out from one of the two holes
located in the lower part of the back of the unit.
Opportunely close the unused hole.
2.2.1 - Removal of the front panel (Fig.3)
•
Open the right door (D) on the front panel (P) and turn it rightwards.
•
Undo the fixing screw (X) located inside the right door (D).
•
Lift the front panel (P) upwards and remove it.
2.2.2 - Access to internal components
•
After removing the front panel, remove the two screws (V) which fix the cover of the electric panel (Q).
(Fig.6)
•
Remove the four screws (V1) and rotate the panel rightwards to have access to the components behind
the electric panel (Q). (Fig.6a)
•
It is possible to release the electric panel and to hook it with the specific grooves; this way it is possible
to access all the components inside the appliance and to easily proceed with installation or maintenance
of the appliance.
Inside the electric board are located the components described in paragraph "3.4.3 Electrical connections".
(fig.6b)
EN - 14
X
Publicité
