Skandika CARDIOCROSS CARBON PRO II Instructions De Montage Et Mode D'emploi page 33

Assembly instructions
Step 2: Assemble the handle bars
1. Mount the left mast cover (L) (41) on the bar on the left side of the mast and the right mast
cover (R) (41~1) on the bar on the right side of the mast. Adjust the mast cover on the side
covers on left (42) and right (43) side and secure them with six tapping screws (84). Please
use the accompanying Allen key and Philips head screwdriver for this purpose.
2. Place the spring washer (101), the lower handle bar (L) as well as the lower handle bar ( R)
corresponding to the bar of the mast and lock them with the hex head screw (70) and two flat
washers (97). Please use the accompanying 12- open end wrench for this purpose.
3. Connect the swinging arm (L) (13) with the lower handle bar (L) and lock it with the round
head Allen screw (75). Please use the accompanying Allen key and Philips head screwdriver
for this purpose. Repeat the same procedure on the right side.
Step 3: Assemble the connecting arms
1. Use a hex head screw (71) with a flat washer (98) and a locking hex head nut (105) to attach
the rod termination (23) at the end of the lower handle bar (L). Please use the 13/14 and 12
open-end wrench. Repeat the procedure on the right side.
2. Use a round head Allen key (156), a flat washer (94) and a locking hex head nut (89) to fix
the outer flat rod (144) on the frame. Please use the 13/14 and 12 open end wrench for this
purpose. Then use a round head Allen screw (155), a flat washer (94) and a locking hex head
nut (89) to fix the inner flat rod (143) to the rail connection (15). Please use the 13/14 and 12
open end wrench for this purpose.
Step 4: Assemble the cover
1. To mount the connecting cover A(L) (59) and the connecting cover B (R) (60) on both sides
of lower handle bars, fix it with four round head Philips screws (79). Please use the Allen key
and Philips screwdriver for this purpose.
2. To mount the side covers (52) on the right as well as the left pedal arm, use the four round
head Philips screw (79). Please use the accompanying Allen key and Philips screwdriver for
this purpose.
3. Use the round head tapping screws (84) to connect the front handle bar (L) (54) with the rear
(L) (55). Please use the accompanying Allen key and Philips screwdriver for this purpose.
4. Use the two round head Philips screw (79) to connect the front stabilizing cladding (61) with
the rear stabilizers on both sides of the frame. Please use the accompanying Allen key and
Philips screwdriver for this purpose.
5. Fix the rear stabilizing cladding (L) (62) with a round head Philips screw (79) on the guide rail
(16). Please use the accompanying Allen key and Philips screwdriver for this purpose. Re-
peat the procedure for the rear stabilizing cladding (R) (pos. 63) on the other side.
33