Assembly Instructions - Skandika CARDIOCROSS CARBON PRO II Instructions De Montage Et Mode D'emploi

Assembly instructions

Assembling
Unpack the gym equipment
1. Take the help of another person as few parts of your new cross trainer are bulky and heavy.
2. Use a box cutter to cut the cardboard box along the dotted line.
3. Remove all the parts from the carton and check them for completeness and damages.
4. Localize the assembly set. This is subdivided into steps. First take out the tools. Take out the parts
for the specified step respectively in order to facilitate the installation.
Carry out the assembly carefully as the damages and defects which are caused due to the errors in
assembly cannot be covered under warranty and guarantee. Therefore, read through the instructions
in detail before assembling, maintain the sequence of the assembly steps and comply with the indivi-
dual assembly steps. The assembly of the gym equipment must be carried out carefully by the adults.
Carry out the assembly of your gym equipment at a place which should be flat, clean and free from the
objects obstructing the assembly. The assembly should be carried out by two people. Workout can be
started only after the assembly of the gym equipment is completed.
Step 1: Assembly of the mast
1. Pull the computer cable (32) with the help of the wire, which is found in the mast, through the mast
(10). Insert the mast in the U-shaped base and pull out the computer cable (32). Use the hex head
screw (119) with lock washer (120) and a hexagon head screw (121) with a lock washer (120) and a
dome shaped washer (114) to mount the mast. Please use 13/14- open end wrench for this purpose.
Caution: Take care by all means to avoid the damage to the computer cable inside the mast.
2. Connect the computer cable (32) along with the hand pulse cable (37) to the computer (31), then
mount the computer on the given mounting at the end of the mast and secure it with four round
head Philips screws (78).
3. Mount two guide rails (16) on the base of the frame and secure them with two round-
head Allen screws (76), flat washers (94) and locking hexagonal nuts (89). Ple-
ase use 13/14- open end wrench and the accompanying Allen key for this purpose.
Caution: Please make sure that the flat washer is under the nut and not under the screw.
4. Place the rail connection (15) between the guide rails (16) and screw it together with four round-
head Allen screws (76), four split washers (120) and the flat washers (114). Please use the accom-
panying Allen key and the Philips head screwdriver.
32