Publicité
Les langues disponibles
Les langues disponibles
en-us_main.book.book Page 55 Thursday, May 25, 2023 5:08 PM
Parts & Features
Problem
Oven control beeps
Electronic control has detected a fault condition.
and displays any F
• Turn off the oven function you are using to clear the display and stop beeping. Reprogram
code error.
Displayed colon in
This means that the product has just been plugged in, or that it has experienced a
the clock is flashing
power interruption.
• This is normal. Reset the clock or press any button to stop the flashing.
CLEAN and door
The Self Clean cycle has been selected, but the door is not closed.
flash in the display
• Close the oven door.
(On some models)
The oven is locked because of the Control Lock / Lockout feature.
k
is on in the display
when you want to
• Deactivate the Control Lock / Lockout feature.
cook (On some
models)
Oven light does not
It is time to replace the lamp or the lamp is loose.
work.
• Replace or tighten lamp. See "Changing the Oven Light" section in this Owner's Manual.
Convection fan
Convection fan stops during a convection bake cycle. It is done to allow for more even
stops. (During
heating during the cycle.
Conv.Bake mode)
• This is not a failure of the range and should be considered normal operation.
Fan operation
This is to ensure even baking results.
(During Bake mode)
• It is normal for the fan to operate periodically throughout a normal bake cycle in the oven.
Cooling fan
The fan turns off automatically when the electronic components have cooled
continues to run
sufficiently.
after oven is turned
• This is normal.
off.
Oven will not Self
The oven temperature is too high to set a Self Clean operation.
Clean. (On some
• Allow the appliance to cool and reset the controls.
models)
Oven controls improperly set.
• See the Self Clean section.
A Self Clean cycle cannot be started if the oven Control Lock / Lockout feature is active.
• See the "Control Lock / Lockout" in "Changing Oven Settings" section.
Oven door does not
Oven is too hot.
open after a Self
• Allow the oven to cool below locking temperature.
Clean cycle (On some
models)
The control and door may be locked.
• Allow about one hour for the oven to cool after the completion of a Self Clean cycle. The
oven. If fault recurs, record fault number and call for service.
- [Case 1]
Code: F-3
Cause: Key short error
- [Case 2]
Code: F-19
Cause: Oven not heating
door can be opened when the lock
TROUBLESHOOTING
Possible Cause & Solution
is no longer displayed.
k
55
Publicité
