Publicité
6.1 Status messages
EN
The following status messages give information about what mode the unit is in or what routine service is being
performed.
6.1.1 Nederman FlexPAK Off (Off mode)
The unit is in Off mode, which is also the unit's start menu. The unit can also go into Off mode if something is
wrong, such as if an alarm is activated. The pump motor is off, there is no vacuum, the FCV is closed, and the unit
cannot be activated by a pilot signal.
FlexPak
Hi Vacuum Unit
OFF
Time To Service
2000 hours
6.1.2 Nederman FlexPAK Standby (Standby mode)
The unit is in Standby mode. The pump motor is off, there is no vacuum, the FCV is closed, and the unit is waiting
for a pilot signal to go into Running mode.
NEDERMAN
FLEXPAK
Standby
Wai ng For
Pilot Signal
Mo 15:33
6.1.3 Running (Running mode)
The unit is in Running mode. The pump motor is on and the unit generates a vacuum. The FCV is closed. The cur-
rent vacuum of the unit is shown on the display, for example, -20 kPa.
Running
kPA
DIRTm
OTTmr
Exhaust
Air Temp
28
All manuals and user guides at all-guides.com
FlexPAK 800/1000 DX
ESC
ESC
-20
00:00 s
00:00 h
60°C
ESC
TimeToService: The amount of time until next sched-
uled service. The default setting is 2000 hours.
OK
OK
DIRTm: The amount of time before the unit goes into
Idling mode. The default is 10 seconds.
OTTmr: If the Overtime timer has been activated,
OTTmr shows the elapsed time since the overtime
timer started.
OK
Publicité
