Automatic cleaning using the
PYROLYTIC cycle
During the PYROLYTIC cycle, the internal
temperature of the oven reaches 500°C. The
pyrolytic cycle is activated and burns away food
and grime residues. Dirt is literally incinerated.
Keep children away from the appliance during the
automatic cleaning cycle as surfaces may become
very hot. Particles may ignite inside the oven as a
result of the combustion process. There is no cause
for concern: this process is both normal and hazard-
free.
! The oven advises the user when it is necessary to
perform a cleaning cycle; the display shows the text
"PYROLYTIC recommended - START?"; select "yes"
to set the desired cleaning cycle level.
Before initiating the PYROLYTIC cycle:
! We recommend the duration of the first automatic
cleaning cycle is set to 120 minutes.
! The oven should be cold. If the oven is too hot, the
pyrolytic cycle may not start. Wait for the oven to
cool down.
• remove large or coarse food residues from the
inside of the oven using a damp sponge. Do not
use detergents;
• remove all the accessories, the guide rails and the
supporting frames;
• do not place tea towels or pot holders over the
oven handle.
! The programme may only be started once the oven
door has been closed.
! If the divider is inside the oven, the pyrolytic cycle
will not start.
To activate the PYROLYTIC cycle, press the
button followed by the "MENU" button.
1. Select the PYROLYTIC command and press "OK".
2. Select the desired PYROLYTIC cycle level by
adjusting the
or
buttons. The PYROLYTIC cycle
has three default time settings which cannot be
modified:
1. Economy (ECO): duration 1 hour
2. Normal (NOR): duration 1 hour and 30 minutes
All manuals and user guides at all-guides.com
3. Intensive (INT): duration 2 hours.
Press the "OK" button to confirm.
Press the "START/STOP" button to begin the
PYROLYTIC cycle.
Safety devices
• The door locks automatically after a few minutes;
• if a malfunction occurs, the heating elements will
be switched off;
• once the oven door has been locked, you cannot
change the duration and end time settings.
! Programming is possible only after selecting the
PYROLYTIC cycle mode.
Programming delayed automatic cleaning
1. Press the selector button
option will appear on the display.
2. Adjust the value using the
3. Press the "OK" button to confirm.
4. Press the "START/STOP" button to activate the
programmed process.
5. When the cooking time has elapsed, a buzzer
sounds and the oven switches off.
• For example: it is 9:00 a.m. and the Economy
PYROLYTIC cycle has been selected: default set
time 1 hour. 12:30 is scheduled as the end time.
The programme will start automatically at 11:30
a.m.
The message WAITING shows that a programme
has been scheduled. The display shows the
pyrolytic cycle end time and duration alternately.
To cancel programming, switch the oven off
Once the automatic cleaning cycle is over
You will have to wait until the temperature inside the
oven has cooled down sufficiently before you can
open the oven door. You will notice some white dust
deposits on the bottom and the sides of your oven;
remove these deposits with a damp sponge once
the oven has cooled down completely. Alternatively,
you can make use of the already heated oven, in
which case it is not necessary to remove the
deposits, they are completely harmless and will not
affect your food in any way.
; the END COOKING
-
+
and
buttons.
.
43
GB