SCHOLTES BC 199DT P XA Instructions D'installation page 24

Installation
! ! ! ! ! Please keep this instruction booklet in a safe place
GB
for future reference. If the appliance is sold, given
away or moved, please sure the booklet is also
passed on to the new owners so that they may
benefit from the advice contained within it.
! Please read this manual carefully: it contains
important information concerning the safe operation,
installation and maintenance of the appliance.
Positioning
! ! ! ! ! Keep all packaging material out of reach of
children. It may present a choking or suffocation
hazard (see Precautions and tips).
! ! ! ! ! The appliance must be installed by a qualified
professional in accordance with the instructions
provided. Incorrect installation may damage
property or cause harm to people or animals.
Built-in appliance
Use an appropriate cabinet to ensure that the
appliance operates properly:
• the panels adjacent to the oven must be made of
heat-resistant material;
• cabinets with a veneer exterior must be
assembled with glues which can withstand
temperatures of up to 100°C;
• to install the oven under the counter (see diagram)
or in a kitchen unit, the cabinet must have the
following dimensions:
! ! ! ! ! The appliance must not come into contact with
electrical parts once it has been installed.
The indications for consumption given on the data
plate have been calculated for this type of
installation.
24
All manuals and user guides at all-guides.com
Ventilation
To ensure adequate ventilation is provided, the back
panel of the cabinet must be
removed. It is advisable to
install the oven so that it rests
on two strips of wood, or on a
completely flat surface with an
opening of at least 45 x 560
mm (see figures).
Centring and fixingù
Position the 4 tabs on the side of the oven so that
they are aligned with the 4 holes on the outer frame.
Adjust the tabs in accordance with the thickness of
the cabinet side panel, as shown below:
20 mm thick: take off the
removable part of the tab (see
diagram);
18 mm thick: use the first
groove, which has already
been set in the factory (see
diagram);
16 mm thick: use the second
groove (see diagram).
Secure the appliance to the cabinet by opening the
oven door and inserting 4 screws into the 4 holes on
the outer frame.
! ! ! ! ! All parts which ensure the safe operation of the
appliance must not be removable without the aid of
a tool.
min. 20 mm
FAN ASSISTED
MODE
min. 45 mm