Télécharger Imprimer la page

SCHOLTES BC 199DT P XA Instructions D'installation page 42

Masquer les pouces Voir aussi pour BC 199DT P XA:

Publicité

Les langues disponibles

Les langues disponibles

Care and maintenance
Switching the appliance off
GB
Disconnect your appliance from the electricity
supply before carrying out any work on it.
Cleaning the appliance
• The stainless steel or enamel-coated external
parts and the rubber seals may be cleaned using
a sponge that has been soaked in lukewarm water
and neutral soap. Use specialised products for
the removal of stubborn stains. After cleaning,
rinse and dry thoroughly. Do not use abrasive
powders or corrosive substances.
• The inside of the oven should ideally be cleaned
after each use, while it is still lukewarm. Use hot
water and detergent, then rinse well and dry with
a soft cloth. Do not use abrasive products.
• All accessories - with the exception of the sliding
racks - can be washed like everyday crockery,
and are even dishwasher safe.
! Never use steam cleaners or pressure cleaners on
the appliance.
Cleaning the oven door
Clean the glass part of the oven door using a
sponge and a non-abrasive cleaning product, then
dry thoroughly with a soft cloth. Do not use rough
abrasive material or sharp metal scrapers as these
could scratch the surface and cause the glass to
crack.
For more thorough cleaning purposes, the oven door
may be removed:
1. Open the oven door fully (see diagram).
2. Use a screwdriver to lift up and turn the small
levers F located on the two hinges (see diagram).
42
All manuals and user guides at all-guides.com
F
3. Grip the door on the two
outer sides and close it
approximately half way. Pull
the door towards you, lifting it
out of its seat (see diagram).
To replace the door, reverse
this sequence.
Inspecting the seals
Check the door seals around the oven at regular
intervals. If the seals are damaged, please contact
your nearest Service Centre (see Assistance). We
recommend that the oven is not used until the seals
have been replaced.
Replacing the light bulb
Lamp Holder
compartment
Lamp
Glass cover
wattage 25 W, cap G 9.
3. Replace the glass cover (see diagram).
! Do not touch the light bulb directly with your hands.
Sliding rack kit assembly
To assemble the sliding
racks:
1. Remove the two frames,
A
lifting them away from the
spacers A (see figure).
2. Choose which shelf to use
Left
Right guide
with the sliding rack. Paying
guide rail
rail
attention to the direction in
which the sliding rack is to be
B
extracted, position joint B and
C
then joint C on the frame.
3. Secure the two frames with
the guide rails using the holes
provided on the oven walls
(see diagram). The holes for
the left frame are situated at
D
the top, while the holes for the
right frame are at the bottom.
4. Finally, fit the frames on the spacers A.
To replace the
oven light bulb:
1. Remove the
glass cover of the
lamp-holder.
2. Remove the
light bulb and
replace it with a
similar one:
halogen lamp
voltage 230 V,

Publicité

loading

Ce manuel est également adapté pour:

Bc 199d p xaBcg 199d p