Boom; Rastomat; Transport - Vermeiren Pratic Mode D'emploi

PATIENT BOOM
The boom can be mounted on either side of the head or foot end (use only for PRACTIC!):
Insert the boom (1) as far as it will go into the relevant socket (2).
Let the locking bolts (3) slide into the slot(4).
Pull the metal loop over the end of the upper frame (5) until the bolts click into one of the three
slots(6).
Pull strap (7) into the metal loop and through the triangle (8); then determine length. Fasten
the strap.

RASTOMAT

To adjust the lying surface for the lower leg, grip the foot-end toggle strap in the middle of the frame.
Pull the lying surface for the lower leg to the desired height. The Rastomat will click into the notch
locks at intervals of approx. 2cm. To lower the surface for the lower leg, use the foot-end toggle strap
and pull it to the upper position. The Rastomat will then remove the lock. You can now completely
lower the leg surface slowly until it rests on the bed frame.
!
No people or objects allowed nearby when adjusting8 risk of injury!
!
Only make adjustments when the grips are at the foot of the bed. Otherwise the bed can tip
over and the adjustment mechanism damaged.

TRANSPORT

To avoid damage when transporting, the overhead boom should be detached. Remove the power
cable and make sure that no cables hang near the floor.
!
The bed is not suitable for transporting patients.
!
Patients may only be transported when in the lowest horizontal position!
Should the bed be transported over greater distances, use the transport set to do so.

1 = Boom

2 = Boom insertion pipe
3 = Locking bolts
4 = Location slot
5 = Boom frame
6 = Slots
7 = Strap
8 = Triangle
16
EN
PRATIC
2010-11