Vermeiren Pratic Mode D'emploi page 10

EN
The metal side railing can be lowered by gripping the upper side railing cross bar and pulling down the
knob (1) on the underside of the railing. The side railing can then be folded in down in direction A1. To
raise once again, grip the upper side member of the railing and pull the railing upward until you hear
the railing pull button go click and the head section of the side railing is vertical to the front section of
the head rest surface (A2).
Wooden side railings are also available. The following provides a description of how to install the
wooden side railings.
Insert the short bolt rails (1) on the right and left in the upper wood slat. Insert the long bolt
A.
rails (2) right and left in the lower wood slat.
Insert the long bolt rails (2) in the wood slat in the sliding rail for the head and
foot section one by one and secure them by inserting the rails until the upper end is
inserted and clicks. On one side release this rail again until the tip by pressing the position
locking button (5) and pulling the upper wooden slat gently upwards.
Let the bolt rails (2) fall from the sliding rail once more until the tip of the rail is just barely in
the guide. The short bolt rail (1) will now be inserted together with the wooden slat between
the walls of the long bolt rails and the entire bolt rail system (1) + (2) will placed in the relevant
sliding rail (4) by pulling upwards when grasping only the upper wooden slat and then locking
the structure in position.
Insert the locknuts (6) and tighten them manually.
B.
1 = Short bolt rails
2 = Long bolt rails
3 = Wood slats (2 pieces each side)
Sliding rail
4 =
5 = Position locking button
6 = Locknut
9
PRATIC
2010-11