Transformer Connections; Disabling Box (If Installed On The Bed) - Vermeiren Pratic Mode D'emploi

TRANSFORMER CONNECTIONS

Connect only to power sockets conforming to VDE (220 V / 230 V, 50Hz).
6
1 2
The motor connection plugs are labeled with the same number as the connections on the
"
!
Take hold of the plug only to remove it from the power socket.
"
#
Do not touch the plug with wet hands.
"
#
The power connection must not have any loops or kinks and should not pass around sharp
edges.
"
#
Protect the power connection and the cable leading to the manual switch from being crushed.
"
#
Do not place any objects on the connection and the cable, and protect them from mechanical
loads.

DISABLING BOX (IF INSTALLED ON THE BED)

This paragraph shall be used if the disabling box is installed on the bed and in combination
with the manual control without lock function.
A disabling box is situated between the transformer and the manual control to prevent involuntary
electric operation of the nursing bed (mounted on the cross bar of the bed undercarriage). It has
rotating switches that activate or prevent manual operation.
The nursing bed may not be used without the disabling box. Do not remove the disabling box. The
manufacturer will then no longer be liable for any damage which might occur.
1
#
3
"
#
Protect electric cables from crushing.
3 4 5
transformer.
4
$
2
10
5 = Connection of disabling box
6 = Transformer / control box
1 = Disabling box
2 = Transformer connection
3 = Manual control connection
4 = Disabling control
#
= Disabled
$
= Released
EN
PRATIC
2010-11