Grillo Climber 710 Manuel D'utilisation page 13

CHANGING THE BELTS
The movement is transmitted from the motor to the hydraulic transmission and to the blades by means of
two v-belts. Replace the belts as soon as they show signs of wear!
Their replacement and subsequent adjustment are fairly complex procedures and must be carried out by
an Authorised After-Sales Service Centre.
For cutting deck drive belt, the three belt guides beside the deck pulley have to be removed (A, fig. 19);
release the belt stretcher spring (fig. 20).
ALWAYS USE ORIGINAL BELTS!
TRACTION RELEASE LEVER
The traction release device is located at the back of the machine (fig. 22); if the machine breaks down, to
allow it to be towed or moved by hand, move the lever to idle position (B, fig. 22). In the position (A)
shown in fig. 22 the machine is in working condition.
TROUBLE-SHOOTING:
CAUSE
– Battery not supplying power
Dashboard ON, but starter motor does not turn over with key in "AVV" (ON) pos.
– Battery not supplying enough power
– Start-up go-ahead not given
– Carburation problems
– Deposits or dirt in fuel
– No petrol flow
– Fault in ignition system
Climber 7.10 / Translation of the original instructions
PROBLEM
Dashboard OFF with key in "AVV." (ON) pos.
Difficult starting or irregular running of engine
Starter motor turns over but engine does not start
REMEDY
– Check connecting cables
– Recharge battery
– Change the fuse
– Recharge battery
– Travel lever in stop position
– Disengage blades
– Sit in the driver's seat
– Check the three safety sensors (seat –
blades engagement - forward lever)
– Clean or change the air filter
– Adjust the carburettor (follow engine manual
instructions)
– Empty the tank and use fresh petrol
– Check and change the petrol filter if necessary
– Check that the choke has been activated (if
engine is cold)
– Check petrol level in tank
– Check wiring of carburettor opening control
– Check petrol filter (and change if necessary)
- Check that the vent on the tank cap is not
blocked
– Check that the caps of the sparkplugs are
correctly fastened
11