Switching The Unit On And Off (Button T1); Cooling Function - Olimpia splendid UNICO Série Manuel D'installation

D5 External air intake switch.
D6 Night operation switch.
D7 Automatic operation switch.
D8 First operating program switch.
D9 Second operating program switch.
D10 Temperature indicator (thermometer) or time
indicator (H M).
The remote control is also equipped with a cover with a
cursor that can be positioned so as to permit access only
to the ON/OFF, AUTOMATIC MODE and NIGHT MODE
buttons.
With the cover in this position the air conditioner can be
used but none of the settings can be tampered with.
3.4.2
In order to command the machine via the remote control,
Switching on
the main switch on the electric line (ask the technician
and control of
who installed the machine about the main switch position)
operation
must be on and the mains plug of the machine must be
plugged in.
Once these operations have been carried out, the
machine may be regulated using the remote control.
To send commands to the air conditioner, point the front
of the remote control toward the air conditioner control
panel.
The device emits a beep when it receives a command.
The maximum distance for transmission of commands is
about 8 meters.
3.4.3
This button turns the machine on or off.
Switching the
The machine's control system has a memory, therefore
unit on and off
any setting will not be lost when it is turned off.
(button T1)
This button serves to switch the air conditioner on or off
for brief periods of time.
In case of prolonged stop of the machine, it must be
deactivated turning the main switch off or unplugging the
machine from the mains.
3.4.4
By means of this button the machine is automatically
Well being mode
regulated in order to create an optimal comfort tempera-
(Automatic)
ture in the air-conditioned room.
(button T2)
The machine's temperature is automatically regulated
according to the room's temperature.
The fan speed is also automatically regulated according
to the set temperature (except in dehumidification use).
3.4.5
When used in this mode, the air conditioner dehumidifies

Cooling function

and cools the room.
Button T4 is used to select the operating mode.
Press until the snowflake symbol appears on the display.
First set the desired temperature and fan speed (see the
relative paragraphs).
After three minutes (maximum time), the compressor
should start up and the air conditioner should start cooling
the room.
When the compressor starts you will see a green LED
light up on the control panel.
UNICO-HE
AUTO
T1
Fig. 28
Switching the unit on and off
AUTO
AUTO
+
F S
A E
N T
Fig. 29
Well being mode (Automatic)
AUTO
F
A
N
T4
Fig. 30
Cooling function
AUTO
+
F S
A E
N T
-
T2
+
S
E
T
-
41