Setting Of Time Schedules For 1St And 2Nd Operating Program (Progr. 1 And Progr. 2); Starting And Stopping Operating Programs - Olimpia splendid UNICO Série Manuel D'installation

3.4.15
To set the times for starting and stopping the two air
Setting of time
conditioner programs, proceed as follows:
schedules for 1st
and 2nd
a) Press button Time and Program Setting, as many
Operating
times as necessary to display the PROGR. 1 ON
Program
indicator (Time to start 1st program).
(PROGR. 1 and
b) Press toggle button T7 to increase or decrease the
PROGR. 2)
numerical display of the time when you want program
1 to start.
Every time you press one end of the toggle button
the time setting increases or decreases by 30
minutes.
c) Press button T6 Time and Program Setting, as many
times as necessary to display the PROGR. 1 OFF
indicator (Time to stop 1st program).
d) Press toggle button T7 to increase or decrease the
numerical display of the time when you want program
1 to stop. Every time you press one end of the toggle
button the time setting increases or decreases by 30
minutes.
e) Press button Time and Program Setting, as many
times as necessary to display the PROGR. 2 ON
indicator (Time to start 2nd program).
f) Press toggle button T7 to increase or decrease the
numerical display of the time when you want program
2 to start.
Every time you press one end of the toggle button
the time setting increases or decreases by 30
minutes.
g) Press button T6 Time and Program Setting, as many
times as necessary to display the PROGR. 2 OFF
indicator (Time to stop 2nd program).
h) Press toggle button T7 to increase or decrease the
numerical display of the time when you want program
1 to stop. Every time you press one end of the toggle
button the time setting increases or decreases by 30
minutes.
i) To return to the normal operating mode just press
button T6 as many times as necessary to cancel the
program indications from the display.
3.4.16
After making the settings for the operating programs, they
Starting and
can be used or not, as needed.
stopping
Either or both of the programs can be used.
operating
In particular, when you press T11 to run the programs,
programs
the following things occur:
Use of Program no. 1 only
Use of Program no. 2 only
Use of Programs 1 and 2
Disuse of both programs.
UNICO-HE
1
+
F S
A E
N T
-
T7
T6
2
+
F S
A E
N T
-
T7
T6
Fig. 39
Setting of time schedules for 1st and 2nd Operating
Program (PROGR. 1 and PROGR. 2)
1
+
F S
A E
N T
-
2
Fig. 40

Starting and stopping operating programs

2
+
F S
A E
N T
-
T7
T6
2
+
F S
A E
N T
-
T7
T6
T11
1
2
A
45