B - Appliance Switching On/Off; Ventilation Mode (Fan); Cooling Mode (Cool); Dehumidification Mode (Dry) - Olimpia splendid DOLCECLIMA COMPACT Instructions Pour L'installation, L'emploi Et L'entretien

Masquer les pouces Voir aussi pour DOLCECLIMA COMPACT:

Les langues disponibles

3.4.b - Appliance switching on/off

a. the appliance can be switched on or off for short periods by pressing B1 on the remote control or

SW1 on the control panel (if the appliance is switched off for a long period then it should be deactivated

by removing the plug from the mains supply.

b. The corresponding LED L2 lights up to indicate that the appliance is switched off.

c. in this condition, press B1 again on the remote control (or SW1 on the control panel) to restore all the

formerly selected functions.

When the appliance is off all the working timers are 'reset'.

a. When this operating mode is used the appliance has no effect on the temperature or humidity of the en-

vironment, it merely circulates the air.

b. this mode can be selected by pressing B2 or SW2 until the fan only symbol ( ) is activated on the remote

control and on the control panel display.

c. in this operating mode the internal fan is always on and the required fan speed can be selected at any

time by pressing key B6 (only from the remote control) (symbol 6 on the remote control).

a. In this mode the appliance cools and dehumidifies the environment.

this mode can be selected by pressing B2 or SW2 until the cooling only symbol

( ) is activated on the remote control and on the control panel display.

b. the internal fan is always on at automatic speed or (only from the remote control) at the selected speed.

c. the temperature set-point (tset) can be adjusted from 17°C to 30°C (from 61 f to 86 f if present) in

1°C steps by means of B4/B5 or SW3/SW4, and its value is shown both on remote and local interfaces.

d. three minutes (maximum) after the activation of this operating mode the compressor starts and the ap-

pliance starts to distribute cold air.

a. This mode can be selected by pressing B2 or SW2 until the dehumidification only symbol ( ) is activated

on the remote control and on the control panel display.

b. this mode is similar to cooling mode, except that:

fan speed selection not active (Set temperature) set equal to "tamb" (ambient temperature).

c. In dehumidification mode only, the appliance can operate with only the condensate drain pipe connected

(12) and without the flexible air expulsion hose.

EN - 24

Table des Matières