EUROM Force 1600 Livret D'instructions page 31

SAFETY FEATURES
The nozzle is fitted with a 'lock' for safety. If you push the button to the left, the handle is locked
and will not function. Unlock the handle by pushing this switch back to the original position.
The motor is fitted with a thermal safety feature that switches it off when it overheats. In
principle, it will start again automatically when it is sufficiently cooled. But it is better to switch
the machine off for 5 to 10 minutes, wait, and then start it again. Identify the cause of the
overheating and remove it. If this problem recurs, stop using the machine and contact your
supplier / repair service.
MAINTENANCE
Attention: Always take the plug out of the socket before you execute maintenance!
 Flush the water supply hose, the high-pressure
hose, the jet lance, the nozzle and other
accessories thoroughly before you use them.
 Carefully remove dust, sand or other dirt from the
connections.
 Regularly clean the nozzle with the pin supplied
and then flush it thoroughly (against the direction
of the jet). To do this you must remove the nozzle
from the lance.
 Regularly clean the filter in the water inlet. To do
this, unscrew the water inlet connector, remove
the filter with a screwdriver or similar tool and
check that it is undamaged. Fasten everything
firmly and correctly in the appropriate place.
Never use the cleaner without a filter!
 Keep the ventilation openings of the machine
clean in order to prevent obstruction of the
cooling function.
 Regularly grease the O-rings of the connectors in
order to prevent them from drying out.
 Repairs and inspections must only be carried out by your supplier or appropriately trained
and authorised persons. Inexpertly executed repairs will nullify the guarantee.
Never carry out repairs!
PROBLEMS AND SOLUTIONS
Switch off the device and remove the plug from the power socket before carrying out any
maintenance or checks. Repairs must always be carried out by technicians qualified for that
purpose. You may well be able to solve any minor issues by means of the diagram below. If in
doubt, consult you dealer or service point.
The machine does not start
- Is the plug inserted into the socket?
- Is the socket not in good working order? Try another.
- Is the fuse burnt out? Replace it.
- Extension cable broken. Use another cable.
31