EUROM Force 1600 Livret D'instructions page 29

Les langues disponibles

Fitting the terrace cleaner:

FIRST

 Place the cleaner as close as possible to the water supply.

 The cleaner must be placed on a strong, flat and horizontal surface (handle up).

 The water supply must supply at least the water consumption of the machine (400 l/h)! The

pump must always be supplied with sufficient water. 'Dry operation' causes damage.

 The water temperature may not exceed 40°C. The pressure of the water supplied may not

exceed 0.7 MPA (7 bar).

 Only use clean water with this machine. Impurities or aggressive chemicals damage the

machine!

OPERATION

 Turn the On/Off switch to the O / OFF position.

 Check that the specifications of the socket that you wish to use correspond with those on the

type plate of the machine. If this is the case, insert the plug into the socket.

 Open the water supply completely.

 Unlock the safety lock by pushing the button to the right

 Now squeeze the trigger for several seconds in order to de-aerate the hose.

 Switch the machine on by switching the On/Off button to I / ON. The motor will start briefly,

but will stop again as long as the trigger is not squeezed.

 Hold the spray gun with both hands and aim the lance at the object to be cleaned. Now

squeeze the trigger – the machine will start.

 Take note! Wait at least 3 seconds after releasing the trigger, before squeezing it in again. If

this is not done, the device will 'hiccup'.

 The automatic start/stop system means that the motor only works when the trigger is

squeezed.

 The jet produced by the jet lance can be adjusted from narrow to wide by turning the head of

the lance. Never do this while spraying!

 The Rotating jet nozzle creates a narrow rotating jet.

 The terrace cleaner is intended for the cleaning of hard, even, flat surfaces such as terraces,

small streets, steps, (garden) walls, etc. The cap provides protection from water splashing

back. Attention: the powerful jets can damage softer materials such as paint and wood, etc!

Important: Always point the jet down!