EUROM Force 1600 Livret D'instructions page 30

TIPS FOR USE
 When the water jet leaves the nozzle it causes the handle to recoil. You must therefore
ensure that you are standing in a stable position and have a firm grip. Also ensure that the
high pressure of the water jet does not cause objects to move out of place or fall or fly
around and cause damage. Also select a safe location for yourself!
 Keep your work environment clean and tidy.
 The high-pressure jet can cause damage to, for example, tyres if you move the jet too close.
Always maintain a minimum distance of 30 cm from the object to be cleaned! Always adjust
the distance to the object to be cleaned (and therefore the pressure) appropriately.
 Work from the bottom to the top in the case of vertical surfaces.
 Prevent water from splashing onto undesired places.
 Do not move the cleaner by pulling the electrical cable. Do not lift the machine up with the
cable. Prevent damage to the cable caused by oil, solvents, sharp edges, etc. Do not cover
the machine during use.
 Do not use the machine in an insufficiently ventilated room.
 It is forbidden to clean surfaces containing asbestos with high-pressure.
 If the machine is not used for longer than 5 minutes it must be switched off.
SWITCHING OFF
 Switch the machine off (Button to O / OFF).
 Close the water supply.
 Allow any pressure to escape by squeezing the trigger until no more water comes out of the
nozzle.
 Close the safety lock on the handle.
 Pull the plug out of the socket.
TRANSPORT
Always switch off the device and disconnect the water and electricity supply before moving it.
Move the device by lifting it by the grip.
If you want to transport the device on its side (e.g. In a car), turn the device on its wheels and
allow any water to run off. Lift carefully. Protect it against bumps and jolts, strong vibrations,
moving and tilting.
STORAGE
 Before clearing the machine away, the water must be removed from the pump, the hose and
the accessories. You do this by switching the machine off with the switch and disconnecting
the water supply hose and jet lance. Now start the machine again and squeeze the handle.
Allow the machine to operate until no more water comes out of the spray gun. Then switch
the machine off immediately. Never allow it to 'run dry'!
 Remove the plug from the socket, disconnect the high-pressure hose and hang the hose
and the cable on the hooks.
 Place the handle and the lances in the holders on the machine.
 The machine must be stored frost-free. If this is impossible, have the machine suck in anti-
freeze before you store it. Remember to flush the machine thoroughly with water before
using it again! If the machine nevertheless freezes, have it checked before use. Frost
damage is not covered by the guarantee. Never start a frozen high-pressure cleaner!
30