EUROM Force 1600 Livret D'instructions page 27

DESCRIPTION
1. Grip
2. On/off switch
3. Cable hook
4. Front cover
5. Electrical cable
Two jet lances are supplied with the Force 1600:
- Lance with point/flat jet nozzle: by rotating the extruder head you change the pressure from
high (point jet) to low (flat jet).
- Lance with rotating dirt blaster, for removing stubborn dirt.
The Force 1600 is supplied with a terrace cleaner and a lance extension as standard.
You can spray cold and lukewarm water to a maximum of 40°C. Hotter water can damage the
pump. Do not use water that contains dirt, sand or chemicals – this may damage the machine
and the operation and shorten the life span of the machine.
The safety regulations specified elsewhere in this booklet must be taken into account at all
times in order to prevent damage to the machine and the surface to be cleaned and personal
injury.
27
6. Water inlet
7. Hook for high-pressure
hose
8. Jet gun
9. High-pressure hose
10. Jet lance
11. Jet gun holder
12. Rear cover
13. Water outlet
14. Wheel