WAGNER HC 940 Mode D'emploi page 42

Starting operation
4. Starting operation
4.1 Swivel mechanism of the material
feed pump
1. Transport position (fig. 8)
Transport unit only when the material feed pump is in the
horizontal position.
Swiveling the material feed pump to a horizontal position
also allows removal of the pump from the coating materi-
al container.
Ensure that the locking pin locks.
2.0 Operating position I (fig. 9)
Swiveling the material feed pump to a vertical position al-
lows the material feed pump to be immersed in the coat-
ing material container.
40
GB
2.1 Operating position II (fig. 10)
Swivel material feed pump to a slanted (45°) postion if us-
ing the container suction system (accessory). In this posi-
tion, there is open space under the material feed pump.
4.2 Changing the material feed pump
position
Be careful, as the moving parts of the
swivel mechanism can crush fingers
and feet.
Danger
1. Grip handle (fig. 11, item 1) with one hand.
2. Push locking pin (2) with the other hand.
3. Swivel material feed pump up or down to the desired
position, until the locking pin (2) locks into the new po-
sition.
HC 920 • HC 940 • HC 960