Input / Output Explanations; Usb Host; Usb Device; Power Switch - sylvac D300S V2 Manuel D'utilisation

Input/output explanations

USB Host

Enables measurements sending to a PC. Depending on the operating system,
a driver may be required. It can be downloaded directly from the www.ftdichip.
com website.
The default communication parameters are as follows:
Baud Rate
Parity
Data Bits
Stop Bits
Flow Control
The list of retro-commands recognised by the D300S are found in the « Retro-
command codes list » chapter, P. 24.

USB Device

Enables the connection of measurement instruments through a usb cable
(Proximity-USB, Opto-USB, Power-USB, ...). It is possible to extend the num-
ber of USB ports using a usb hub.
30 USB instruments at the most can be connected at the same time.

Power Switch

Allows the complete switching off of the unit

Sustain pedal input

Two pedals can be connected. Two extra external contacts are also available on
the screw terminal (Switch 1 and 2).

Network connection (RJ45)

The connection to a local network enables amongst other things the retrieval of
recorded data (ex: recorded measurements, configuration files, ...)

Speakers (Jack)

Input enabling the connection to a speaker.

VGA output

Enables the connection of the D300S to an external screen or projector.
Note : The resolution stays identical to the unit's one, i.e. 800x400. It cannot be
modified.
4800
Even
7
2
None
6