General Tolerance; Calibration - sylvac D300S V2 Manuel D'utilisation

Detection of Bluetooth instruments is also done from this menu. (See chapter
"Example of configuration with three Bluetooth® smart" instruments)
E

General tolerance

It is possible to add a general tolerance for the measured part. It can be defi-
ned on the active page only of for all the defined channels.

Calibration

The unit is calibrated in the factory. If recalibration is necessary, the calibration
menu allows it to be done.
Remark: The calibration menu can be ac-
cessed by holding the digital keypad "Enter"
Page 1: allows calibration at 2 reference
points.
19