User Interface; The Setting Menu - sylvac D300S V2 Manuel D'utilisation

User interface

When you first switch on your D300S unit, the default interface will be active as
shown below.
1 Window showing details of channel X
2 Active page indicator
3 Select page X/X
4 Configuration of number of pages (8. max.)
5 General configuration
6 Display type (shift to static mode)
7 Channel individual preset
8 Channel reset
9 Channel configuration
10 Measurement recording (of the active page)
11 Clear all displayed channels
12 Preset all displayed channels
13 Activate the Min/Max extent
While the unit switches off, all parameters are automatically saved. It is also
possible to save your configurations in order to use your D300S for several dif-
ferent workstations.
When an instrument is connected, it is automatically assigned a channel. The
cable's identification address is registered by the unit.
It is therefore vital not to switch it with other instruments. If you disconnect the
cable from the unit and use a different USB port when you next connect it, the
same channel will be reassigned to it.

The Setting menu

This menu enables the modification of all system parameters.
2
1
7
3
10
13
8 9
4 5 6
12
11
10