Waxing The Heater Plate; Waxing With The Waxing Cloth - Miele professional PM 1210 Mode D'emploi

Waxing with the
waxing cloth
Now lay the cleaning cloth back on the infeed table, but this time

move it slightly to the right. The cleaning strip must again face the
heater plate during feeding.
Feed the cleaning cloth through the iron again.

Repeat the process until you reach the right side of the infeed table

and the entire width of the heater plate has been cleaned.
It is essential to wax the heater plate after cleaning.

Waxing the heater plate

To start waxing mode, press and hold the  button for at least
3 seconds and then press the temperature selection button .
The  button will start to flash as soon as the iron has reached the
temperature range .
To deactivate waxing mode, press and hold the  button again for
at least 3 seconds.
If waxing has been successfully carried out in waxing mode for a
period lasting at least 40 seconds, the maintenance interval for
prompting the cleaning and waxing of the heater plate (= red display
symbol ) will be reset.
Sprinkle some wax into the pocket of the waxing cloth.

Use the wax sparingly to avoid the ironing cloth becoming too
smooth.
Close the pocket.

Press the  button to start the waxing process.

Lay the waxing cloth with the rubber-coated side facing

downwards (i.e. towards the roller) and feed it into the heated
rotary iron (heater plate temperature: approx. 180 °C / 356 °F).
Do not feed the wax cloth with the rubber-coated side facing
upwards (i.e. towards the heater plate). This will damage the roller
padding.
en-CA - Cleaning and maintenance
27