Technical And Electrical Safety; Use Of The Appliance - Miele professional PRI318 Mode D'emploi

en - Warning and Safety instructions
– Immediately open all windows and doors and ensure adequate ventilation.
– Close the gas line shut-off valves.
– If you smell gas in a room, under no circumstances should you enter that room carrying
an open flame.
– Do not strike any matches or ignite a cigarette lighter.
– Contact the relevant gas supply company.

Technical and electrical safety


The flatwork ironer must not be operated in the same room as dry-cleaning equipment
using perchloroethylene or solvents containing CFCs.

The flatwork ironer may only be operated in a suitable dry room.

Only operate the flatwork ironer when all removable outer panels are in place so that it is
impossible to touch an electrical component, moving part or hot machine parts.

Do not damage, remove or bypass the safety features or control elements of the flat-
work ironer.

Do not make any alterations to the flatwork ironer unless explicitly authorised to do so
by Miele.

If the control elements or the electrical cabling insulation has been damaged, the flat-
work ironer must not be used until such damage has been repaired.

Repairs may only be carried out by suitably qualified personnel. Incorrect repairs can
cause considerable danger to users.

Faulty components may only be replaced by genuine Miele spare parts. Miele can only
guarantee that the flatwork ironer fully complies with safety requirements if Miele genuine
replacement parts are used.

The electrical safety of this flatwork ironer can only be guaranteed if it is correctly
earthed. It is essential that this standard safety requirement is observed and regularly
tested. If in any doubt, please have the electrical installation inspected by a qualified elec-
trician. Miele cannot be held liable for damages arising from an absent or faulty earth con-
nection.

The flatwork ironer is only completely isolated from the electricity supply if switched off
at the mains isolator, or if the on-site mains fuse is disconnected.

Electrostatic charge may occasionally build up whilst using the flatwork ironer, depend-
ing on the type of fabric and residual moisture.

Use of the appliance


The flatwork ironer must not be operated unsupervised.

The flatwork ironer can be used by people with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, only if they are supervised whilst using
it, or have been shown how to use it in a safe way and recognise and understand the
dangers of such use.
26