Waxing The Heater Plate - Miele professional HM 21-100 Mode D'emploi

en - Cleaning and waxing recommendations
(contains Miele cleaning cloth, Miele waxing cloth and Miele ironing
wax)

Waxing the heater plate

Let the ironer heat up to temperature level "".

Sprinkle some wax into the pocket of the waxing cloth.

Use the wax sparingly to prevent the ironing cloth around the roller
from becoming too smooth.
Excessive waxing impairs the function of the ironer.
Since the waxing cloth is narrower than the heater plate you cannot
wax the entire heater plate width by feeding the cloth through once.
You need to feed the waxing cloth through the ironer several times,
and move it from side to side.
Lay the waxing cloth on the left side of the infeed table. Make sure

that the rubberised interior of the pocket is facing the roller.
The rubberised pocket interior of the waxing cloth must not face
the heater plate during feeding.
Feed the waxing cloth through the ironer from the left side of the in-

feed table until it comes all the way out on the other side.
Lay the waxing cloth back on the infeed table, but this time move it

slightly to the right.
Tip: Only refill the waxing cloth pocket with wax if there are no visible
damp marks in the waxing cloth after the process.
Feeding direction
11