Miele Service - Miele professional PM 1210 Mode D'emploi

The roller cover needs to be changed if there is a visible gap on the
lower edge of the heater plate and roller (laundry outfeed).
The stainless wool padding on the roller may only be replaced by
Miele Service!
The diameter of a new or re-upholstered roller must not be less
than the dimensions indicated below (including the roller cover).
PM 1210, PM 1214:
210–215 mm (8 1/4"- 8 7/6")
Within this range the roller should be wound cylindrically over its
entire length.
During the replacement of the roller padding, Miele Service should
check whether the carbon brushes of the drive motor need to be
replaced as well.
Miele Service
In the event of a malfunction, contact Miele Service. The
Miele Service department requires the model and serial number (SN)
of the rotary iron.
You will find these on the data plate on the inside of the right-hand
side column.
Position of the data plate
en-CA - Cleaning and maintenance
PM 1217
250–255 mm (9 7/8" - 10")
29