Table des Matières
Publicité
again to exit turbo function and "
disappear.
button
LIGHT
Press this button to turn off display light on indoor
unit. "
" icon on remote controller disappears.
Press this button again to turn on display light.
"
" icon is displayed.
button
TEMP
By pressing this button, you can see indoor set tem-
perature, indoor ambient temperature or outdoor
ambient temperature on indoor unit's display. The
setting on remote controller is selected circularly
as below:
no display
●
When selecting "
controller, temperature indicator on indoor unit
displays set temperature.
●
When selecting "
perature indicator on indoor unit displays indoor
ambient temperature.
●
When selecting "
temperature indicator on indoor unit displays
outdoor ambient temperature.
NOTE
●
Outdoor temperature display is not available for some
models. At that time, indoor unit receives "
signal, while it displays indoor set temperature.
'
●
It
s defaulted to display set temperature when turning
on the unit. There is no display in the remote control-
ler.
●
Only for the models whose indoor unit has dual-8
display.
●
When selecting displaying of indoor or outdoor ambi-
ent temperature, indoor temperature indicator
displays corresponding temperature and automatical-
ly turn to display set temperature after three or five
seconds.
button
SLEEP
Under COOL or HEAT mode, press this button to
start up sleep function. "
remote controller. Press this button again to
cancel sleep function and "
" icon will
" or no display with remote
" with remote controller, tem-
" with remote controller,
" icon is displayed on
" icon will disappear.
Function introduction for
combination buttons
Child lock function
Press "+" and "-" simultaneously to turn on or turn
off child lock function. When child lock function is
on, "
" icon is displayed on remote controller. If
you operate the remote controller, the "
will blink three times without sending signal to the
unit.
Temperature display switchover function
Under OFF status, press "-" and "MODE" buttons
simultaneously to switch temperature display
between
and
℃
Auto clean function
Under unit off status, hold "MODE" and "FAN"
buttons simultaneously for 5s to turn on or turn off
the auto clean function. When the auto clean func-
tion is turned on, indoor unit displays "CL". During
the auto clean process of evaporator, the unit will
perform fast cooling or fast heating. There may be
some noise, which is the sound of flowing liquid or
thermal expansion or cold shrinkage. The air con-
ditioner may blow cool or warm air, which is a
normal phenomenon. During cleaning process,
please make sure the room is well ventilated to
avoid affecting the comfort.
NOTE
●
The auto clean function can only work under normal
"
ambient temperature. If the room is dusty, clean
air conditioner once a month; if not, clean air
conditioner once every three months. After the
auto clean function is turned on, you can leave the
room. When auto clean is finished, the air
conditioner will enter standby status.
This function is only available for some models.
●
10
.
℉
" icon
Publicité
Table des Matières
