Table des Matières
Publicité
Introduction for buttons on
remote controller
NOTE
●
This is a general use remote controller. It could be
used for the air conditioner with multifunction. For the
functions which the model doesn't have, if the
corresponding button is pressed on the remote
controller, the unit will keep the original running
status.
After putting through the power, the air conditioner
●
will give out a sound. Power indicator "
After that, you can operate the air conditioner by
using remote controller.
●
Under on status, pressing the button on the remote
controller, the signal icon "
remote controller will blink once and the air condition-
er will give out a sound, which means the signal has
been sent to the air conditioner.
button
ON/OFF
Press this button to turn on the unit. Press this button
again to turn off the unit.
button
Press this button to select your required operation
mode.
AUTO
COOL
●
When selecting auto mode, air conditioner will
operate automatically according to ambient tem-
perature. Set temperature can't be adjusted and
will not be displayed as well. Press "FAN" button
can adjust fan speed. Press "
adjust fan blowing angle.
●
When selecting cool mode, air conditioner will
operate under cool mode. Press "+" or "-"
button to adjust set temperature. Press "FAN"
button to adjust fan speed. Press "
to adjust fan blowing angle.
●
When selecting dry mode, the air conditioner
operates at low speed under dry mode. Under
dry mode, fan speed can't be adjusted. Press
"
" button to adjust fan blowing angle.
●
When selecting fan mode, the air conditioner will
only blow fan, no cooling and no heating. Press
"FAN" button to adjust fan speed. Press "
button to adjust fan blowing angle.
" is ON.
" on the display of
DRY
FAN
HEAT
" button can
" button
●
When selecting heat mode, the air conditioner
operates under heat mode. Press "+" or "-"
button to adjust set temperature. Press "FAN"
button to adjust fan speed. Press "
to adjust fan blowing angle.
NOTE
●
For preventing cold air, after starting up heat mode,
indoor unit will delay the fan operation for 1~5 minutes
(Actual delay time depends on indoor ambient
temperature).
●
Set temperature range from remote cont rolle r:
16~30℃(61-86℉).
●
This mode indicator is not available for some models.
●
Cooling only unit won't receive heat mode signal. If
setting heat mode with remote cont roller, press
ON/OFF button can't start up the unit.
Press "+" or "-" button once increase or decrease
set temperature 1℃(℉). Holding "+" or "-" button, 2s
later, set temperature on remote controller will
change quickly. On releasing button after setting is
finished, temperature indicator on indoor unit will
change accordingly. (Temperature can' t be adjust-
ed under auto mode)
When setting TIMER ON, TIMER OFF or CLOCK,
press "+" or "-" button to adjust time. (Refer to
CLOCK, TIMER ON, TIMER OFF buttons).
FAN
Press this button can set fan speed circularly as:
auto (AUTO), low (
Auto
NOTE
●
Under Auto speed, air conditioner will select proper
fan speed automatically according to ambient tem-
perature.
●
Fan speed under dry mode is low speed.
Press this button can select up & down swing
"
angle. Fan blow angle can be selected circularly as
below:
8
button
button
), medium (
button
" button
), high(
).
Publicité
Table des Matières
