Bolt-Down Instructions; Lock Instructions - SentrySafe EF3428E Manuel Du Propriétaire

Bolt-down instructions

Bolt-down instructions
To provide water-resistance this safe must be bolted down. (hardware supplied)
Bolt down kit contents:
2 Lag screws
2 Washers
Tools needed to bolt safe to a surface:
Drill
Wrench
9/32" (7.2 mm) drill bit – for drilling into wood
3/8" (9.5 mm) drill bit – for drilling into masonry
Select a suitable and convenient location for your safe. Set the
1
safe in place and use the holes provided in the bottom or back
of the safe to mark the location of the holes to be drilled in the
floor.
Move the safe away and drill holes of the appropriate diameter
2
and depth for the type of hardware and the mounting surface
being used (2 each – bolts, washers and masonry anchors).
Place the safe back over the holes and install the fasteners as
3
required. If a water resistant unit was purchased, rubberized
washers are provided. Assure that the area around the safe
hole opening is clean using a damp cloth. Place the rubber side
of the washer facing down against the safe floor and install
the fastener.
F
F
NOTE: SentrySafe is not responsible for any costs incurred if unit is to be replaced.
F
4

Lock instructions

Standard Electronic Lock
To activate lock:
Four alkaline AA batteries, Voltage: 6Vdc, (not included) are required to activate the keypad.
NOTE: Do not use rechargeable batteries or any other type of non-alkaline battery. Do not mix
old and new batteries. Do not mix alkaline and standard batteries.
To install batteries
Using two hands, hold the keypad, thumbs down, on its left and
1
right sides. Push up the keypad with your thumbs, and disconnect
it from the safe by pulling it towards you.
2
Let the disengaged keypad hang by its wires. This will expose the
battery holder.
Install four alkaline AA batteries as illustrated on the back of the battery holder.
3
Reconnect the keypad by inserting the keypad's four posts into the matching holes.
4
Push down to snap into place.
5
NOTICE
Test first with door open!
(See back cover of this manual for your factory code.)
Access codes
There are three possible ways to unlock and access the safe—by entering
its preset Factory Code, your own User Code or a User PIN (Personal
CONFIDENTIAL Identification Number).
You can always open the safe by entering the 5-digit Factory Code. This
code cannot be deleted.
But if you prefer to use your own code, you can program the safe to open
to the 5-digit User Code of your choice. If you wish to give someone else
temporary access to the safe, you can program a User PIN that can later
be erased.
5