Programmable Electronic Lock - SentrySafe Fire-Safe Serie Manuel Du Propriétaire

Programmable Electronic Lock

NOTE: Store code (and keys if equipped) in a secure location
(other than in the safe).
NOTE: SentrySafe offers a secure online location for the entry and
retrieval of your code. Go to www.sentrysafe.com and
register your safe.
Preparing your safe for first time use
Ensure any shipping screws have been removed. Located on
1
the inside of the door.
A Slide out the battery drawer on the side of the keypad.
2
Insert 4 AAA alkaline batteries (do not use rechargeable
B
batteries or other types of non-alkaline batteries).
C Slide battery drawer back into keypad.
l
Find your code on the back of this owner's manual.
3
M100TEST
SN100TEST01*
12345
Warning: Test your code several times before putting valuables inside.
Unlocking your safe
FOR DUAL KEY/ELECTRONIC LOCKS ONLY, insert key into
1
the lock, turn to the 'unlocked' position, then remove the key.
This is a secondary locking feature not an override key. Without
the key you will not be able to open your safe.
Enter the 5 digit factory code on the back of the
A
2
owner's manual.
A green light will indicate the code is correct. You will have
B
4 seconds to turn the handle to unlock your safe.
6
Rotate the handle downward to open the door.
3
This may take a limited amount of force if you have a water
resistant safe.
NOTE: Make sure the handle is in the horizontal position when unlocking the safe.
NOTE: If you exert too much force on the handle, the handle will move without moving the bolts.
When this happens, you will hear a 'click.' DO NOT be alarmed. This feature is designed to
protect the bolts from being over powered by force. If this occurs, simply exert force in the
opposite direction (lifting up) until the handles 'clicks' back into place and repeat steps
1-3 to open your safe.
Locking your safe
Close the door and pull the handle upward until the handle is
1
horizontal.
For water resistant units, additional pressure to the front,
left side of the door may need to be applied prior to rotating
the handle.
FOR DUAL KEY/ELECTRONIC LOCKS ONLY, insert key into
2
the lock, turn to the 'locked' position, then remove the key.
NOTE: The 5 digit factory code cannot be deleted. However, you may add and delete
additional codes.
NOTE: If your safe does not appear to be working properly, please check to make sure you are
using NEW alkaline batteries before contacting SentrySafe Customer Service.
7