Nemox Gelato 5KSc Mode D'emploi page 5

HOW TO CONNECT THE CORD TO A U.K. PLUG: IMPORTANT
The wires in the mains lead are coloured in accordance with the following code:
•Green and yellow:
•Blue:
•Brown:
Please, read the instructions given below before connecting the cord to a plug.
If in doubt, please, consult a qualified electrician. As the colours of the wires in
the mains lead of this appliance may not correspond with the coloured
markings identifyng the terminals in your plug, proceed as follows: the wire
that is coloured Green and Yellow must be connected to the terminal in the
plug which is marked with the letter E or the Earth symbol (G), or coloured
Green or Green and Yellow.
The wire that is coloured Brown must be connected to the terminal which is
marked with the letter L or coloured Red. The wire that is coloured Blue must be
connected to the terminal which is marked with the letter N or coloured Black.
SAFETY POINTS FOR REWIRABLE OR MOULDED PLUG
The mains lead of this appliance may be already fitted with a BS1363 13A plug.
•If your socket outlet is not suitable for the plug, then the plug must be removed (cut off if it is a moulded on plug),
the flexible cord insulation should be stripped back as appropriate and a suitable 3 pin plug fitted.
• WARNING : Dispose of a plug that has been cut from the power supply cord, as such a plug is hazardous if
inserted in a live 13A socket outlet elsewhere in the house.
•Should the fuse need to be replaced an ASTA marked fuse, approved to BS 1362, of the same rating must be
used.
•Always replace the fuse cover after fitting a fuse. The plug must NOT be used if the cover is omitted or lost until a
replacement is obtained. Make certain that only the correct fuse cover is used and fitted.
•For plugs with detachable fuse cover, the replacement must be the same as the colour insert in the base of the
plug, or as directed by the embossed wording on the base of the plug.
•If the detachable fuse cover is lost a replacement may be purchased from a Service Centre.
•Information for supply may also be obtained from the plug manufacturer.
1). Cooling button.
2). Mixing paddle button.
3). Transparent lid.
3a). Hole to add ingredients with cap.
4). Paddle locking ring.
5). Mixing paddle.
6). Ventilation grid.
7). Spatula.
Congratulations!
You have purchased a latest generation
NEMOX ice cream machine.
FIRST USE
•Place GELATO 5Ksc on a flat surface, make
sure that the ventilation grids (6) are not
obstructed. Leave a minimum clearance of
10 cm. around the ventilation grids.
•During use, the appliance must be kept clear
of walls or furniture so as to not obstruct the
inflow and outflow of cooling air. The leakage
of warm or hot air is an integral part of the
operation of the device, that exchanges heat
with the outside for refrigeration.
•Leave the machine in a horizontal position for
8 hours or more before first use, as if it has
English
UK USERS ONLY
Earth
Neutral
Live
8). Water discharge tube.
9). Water discharge tap.
10). Oil seal.
11). Cleaner.
12). Paddle plastic sleeve gasket set.
13). Water discharge tap gasket set.
14). Paddle plastic sleeve.
been tilted during transport, the cooling
agents must re-settle in the correct position.
•Before starting to use the machine, carefully
clean the parts that are in direct or indirect
contact with processed foods (pot, mixing
paddle, paddle inserts, locking ring, lid etc).
•Hygiene is extremely important when dealing
with food. Carefully follow the provisions of
hygiene standards applicable in your country
(HACCP or equivalent).
PREPARING THE MIXTURE
Select the recipe and prepare the mixture,
paying attention to the following:
•Handle the ingredients as required by the
hygiene standards applicable in your country
(HACCP or equivalent).
5