Kärcher MC 50 Mode D'emploi page 67

Clean/ set the spray nozzles:
 Clean the spray nozzle openings using a wire.
 Adjust the spraying direction by turning the spray head
with a wire.
Change the wiper blades:
 Loosen the screw.
 Change the wiper blade.
10.5.26 Replace the side brush (for sweepers)
 Lock parking brake.
 The side-brushes lift up.
 Unscrew screws "A".
 Loosen screws "B".
 Rotate the brush and remove it.
 Screw two screws into the new brush offset by 180°.
 Rotate the brush in the direction of the arrow.
 Screw in the remaining screws and tighten them all.
10.5.27 Remove the sweeping unit (for
sweepers).
 Lower the brush.
 Turn off the appliance.
 Separate the couplings.
 Raise the brush manually and unhook the wire rope.
 Swing the safety pin forward and pull it out.
 Lift off the sweeping system.
30
-
EN 67