Installing The Servos - Conrad Electronic REELY MR-600 Notice D'emploi

12. Installing the Servos

The installation of a servo (not included in the delivery) al-
ways depends on the particular model used. Detailed infor-
mation on this can be found in the construction documents
of the model.
Generally, however, try screwing in the servos (1) in a vi-
bration-dampened manner. This is why rubber bushings (2)
with metal sleeves (3) are usually included with the servos.
When servo arms or linkages are obstructed, the servos
cannot assume the required positions. This causes higher
power consumption and the model cannot be controlled
properly.
Always mount the servo lever (1) at a 90° angle to the link-
age rods (see sketch A).
The rudder or steering travel will not be equal on both sides
if the servo lever is mounted at an angle to the linkage rod
(sketch B) in spite of symmetrical rotting movement of the
servo lever.
Important!
The linkage rods or the rudder linkages must be
designed so that they do not mechanically limit
the possible rotating area of the servo lever early.
The servo may be damaged by this.
Figure 8
Figure 9
49