Conrad Electronic REELY MR-600 Notice D'emploi page 61

Activate the delta and the V-tail mixer:
1. The transmitter must be in normal mode and no mixer must be activated.
2. Switch off the receiver and transmitter.
3. Move the trimming button for the elevator function (see figure 1, item 4) and the trimming button for the motor
function (see figure 1, item 14) to the top, and hold the two trimming buttons in this position. In practice, it has
turned proven its worth to operate the trimming button with the thumb and first finger of one hand.
4. Then switch the transmitter on with the in/off switch (see figure 1, item 8) and observe the green LED for the
function display (see figure 1, item 16).
5. At proper operation, the green LED will flash continually after switching on. This way, the transmitter shows that
the delta mixer is activated. You can now release the trim button again.
6. Repeating steps 2 - 5 will activate the V-tail mixer.
7. Then take the receiver into operation and check if the rudder flaps now deflect according to the illustration in
figure 18 or 19.
8. If required, you can change the running direction at the servos with the reverse function.
9. While one of the two mixers is activated, the green LED for the function display will not remain lit during operation,
but flash.
10. If repeating steps 2 - 5, the transmitter will work in regular operation again and the mixers are deactivated.
61