Assembling The Juicer - MPM MSO-16 Mode D'emploi

ASSEMBLING THE JUICER

14
A
B
18
11
Place the rubber stopper (14) in the hole under the filter bowl (5). Place the sealing sleeve (11) in
1
the filter bowl (5), if not assembled already.
Place the appliance on a smooth, stable and level surface. Install the filter bowl (5) on the motor
unit (1) by locating the 3 bosses (B) on the housing top in the 3 grooves (A) on the filter bowl
2
bottom (5). The grooves (A) will match the bosses (B) in a single specific alignment of the two
parts. Next, place the plug onto the juice spout opening.
Install the the automatic cleaning module (10) onto the mesh filter basket (9). Use a small mesh
3
filter basket (9a) or a large mesh filter basket (9b), depending on how thick you want your juice.
Insert and adjust the stainless steel mesh filter basket (9) with the automatic cleaning module (10)
4 in the filter bowl (5) so that the tab on the filter basket engages the filter bowl groove (5) and the
white marks on the filter basket (9) and filter bowl (5) are aligned.
5 Place the extraction screw (8) in the filter basket (9).