Bodet Cristalys 7 Instructions De Mise En Service Et D'utilisation page 33

message as and when the data arrives.
Sync (impulse) : Select with the [+] button the impulse type between :
For DHF, AFNOR or IRIG-B synchronisation, press
[SELECT] to obtain the "coded time type" menu.
If the clock is in mode COD, the time displayed is the time
received from master clock.
If the clock is in mode LOC, the time displayed depend on
the offset selected in the Time mode menu (Seasonal change
and offset change).
DHF: activation of the DHF synchronisation card.
5. Press [SELECT] to obtain the Test display menu. This menu enables
you to check that all the clock segments are giving the correct display.
6. Press [SELECT]. The Correction menu appears. This enables you
to correct the time base manually. On leaving the factory, the value of
the offset is 0. The value of this offset may vary (using the [+]) between
Min : Minutes // impulses network.
1:2M : ½ Minutes // impulses network.
AFn : Afnor NFS87500A coded time network. After
24 hours without signal, the clock stops.
AFni : Afnor NFS87500A coded time network. After 24 hours without
signal, the clock keeps on working on its own time basis.
IriG : Irig B coded time network.
The default configuration of the AFNOR receiver clock is AFNORi.
nor : normal mode, the clock is already associated to a DHF
transmitter.
Press [SELECT] button to access to the dynamic
DHF synchro menu. This menu allows you to
check the time signal reception. The display
shows the construction of the time message as
and when the data arrives. Press [SELECT] button to exit this menu.
INIT : this mode forces the clock to search a DHF
transmitter. After selecting this mode, the clock
comes back to the time display, initialised to 00h00
01/01/2000. As soon as the clock finds a DHF
transmitter, the clock is synchronised and switched to "nor" mode. The
clock is now associated and synchronised by this transmitter.
33