Declaration Of Conformity - Hilti VC 5-A22 Mode D'emploi

1.5

Declaration of conformity

We declare, on our sole responsibility, that the product described here complies with the applicable directives
and standards. A copy of the declaration of conformity can be found at the end of this documentation.
The technical documentation is filed here:
Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistrasse 6 | 86916 Kaufering, Germany
2 Safety
2.1 General safety instructions for electric devices
WARNING! Read all safety precautions and other instructions.
instructions and other instructions can result in electric shock, fire and/or serious injury.
Keep all safety precautions and instructions for future reference.
▶ This product is not intended for use by persons (including children) with physical, sensory or mental
disabilities or persons lacking the appropriate experience and/or knowledge.
▶ Only persons who are familiar with it, who have been trained on how to use it safely and who understand
the resulting hazards are permitted to use the device. The device is not intended for use by children.
▶ Do not allow children to play with the device. Do not allow unsupervised children to clean the device or
to carry out user-maintenance tasks.
▶ Do not use the device to vacuum up flammable and/or explosive dusts (magnesium or aluminum dust
etc.) or dusts that constitute a health hazard. Do not use the device to vacuum up materials with a
temperature of over 60 °C (e.g. glowing cigarettes, hot ash).
▶ Do not use water, oil, grease or cleaning products.
▶ Do not use gasoline or other flammable liquids for cleaning.
2.2 Careful handling and use of batteries
▶ Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
▶ Do not expose batteries to high temperatures, direct sunlight or fire.
▶ Do not disassemble, crush or incinerate batteries and do not subject them to temperatures over 80 °C
(176 °F).
▶ Do not use or charge batteries that have suffered mechanical impact, have been dropped from a height
or show signs of damage. In this case, always contact your Hilti Service.
▶ If the battery is too hot to touch it may be defective. Put the battery in a place where it is clearly visible
and where there is no risk of fire, at an adequate distance from flammable materials. Allow the battery to
cool down. If it is still too hot to touch after an hour, the battery is faulty. Contact Hilti Service.
2.3 Additional safety instructions for vacuum cleaners
Work area safety
▶ Keep bystanders, children and visitors away while operating the power tool. Distractions may cause you
to lose control of the tool.
Electrical safety
▶ Avoid body contact with earthed / grounded surfaces such as pipes, radiators, cookers, stoves and
refrigerators. There is an increased risk of electric shock if your body is grounded.
▶ Do not expose the vacuum cleaner to rain or wet conditions. Water entering a vacuum cleaner will
increase the risk of electric shock.
Personal safety
▶ Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use
a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of
inattention while operating the power tool may result in serious personal injury.
▶ Wear your personal protective equipment and always wear protective glasses. Depending on the type of
power tool you are using and its purpose, wearing safety equipment such as a dust mask, slip-resistant
safety shoes, a hard hat or hearing protection will reduce the risk of injury.
▶ Do not use the vacuum cleaner in extremely dusty conditions.
▶ Misuse can result in liquid escaping from the battery. Avoid contact with the liquid. Liquid escaping from
the battery can cause skin irritation or burns. If contact occurs, rinse off with water. In the event of the
liquid coming into contact with the eyes, rinse the eyes with plenty of water and consult a doctor.
*2190975*
2190975
Failure to observe the safety
English 11