Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
11 Working with the Vacuum Shredder
► If the wear pad is damaged: Do not use the
vacuum shredder and contact your STIHL
dealer for assistance.
► If you have any doubts, be sure to consult a
STIHL dealer.
10.3
Testing the Battery
► Press button on battery.
The LEDs glow or flash.
► If the LEDs do not glow or flash: Do not use
the battery and contact your STIHL servicing
dealer.
There is a malfunction in the battery.
11 Working with the Vacuum
Shredder
11.1
Holding and Guiding the Vac‐
uum Shredder
1
2
► Hook the carrier rings (2) into the carabiners
(1)
► Hold and control your vacuum shredder with
your left hand on the loop handle and your
right hand on the control handle. Wrap the
thumb of your left hand around the loop han‐
dle and the thumb of your right hand around
the control handle.
11.2
Vacuum shredding
► Point the nozzle at the ground.
► Walk forward slowly and steadily.
For optimum performance, observe the recom‐
mended temperature ranges,
0458-828-9621-C
11.3
► Switch off the vacuum shredder and remove
► Detach the catcher bag from the vacuum
► Hold the catcher bag by the carrying ring in
► Fully unzip the catcher bag and properly dis‐
► Full close the zip.
► Attach the catcher bag to the vacuum shred‐
12 Changing the Vacuum
12.1
► Switch off the vacuum shredder and remove
2
1
► Remove the suction tube.
► Remove the catcher bag.
12.2
► Hold the vacuum shredder firmly with one
► Pull the retaining latch (3) up and hold it there.
► Turn the loop handle (2) 45 degrees counter‐
► Release the retaining latch (3).
► Continue to turn the loop handle (2) counter‐
20.4.
Emptying the Catcher Bag
the battery.
shredder.
such a way that no debris can fall out of the
opening.
pose of the contents.
der.
Shredder for Use as a
Blower
Removing the Suction Tube
and Catcher Bag
the battery.
Turning the Control Handle
1
3
2
hand on the control handle (1).
clockwise.
clockwise until it engages.
English
29
Publicité
Table des Matières
Dépannage
