Troubleshooting - Stihl SHA 56 Notice D'emploi

English

19 Troubleshooting

19.1 Troubleshooting the vacuum shredder or battery
Fault LEDs on the
battery
The vacuum 1 LED flashing
shredder does green.
not start when
switched on.
1 LED emits
red light.
3 LEDs flash
red.
3 LEDs light
up red.
4 LEDs flash
red.
The vacuum 3 LEDs light
shredder cuts out up red.
during operation.
The suction
power is too low.
The runtime of
the vacuum
shredder is too
short.
Charging does 1 LED emits
not start when red light.
the battery is
32
Cause
State of charge of the
battery is too low.
The battery is too
warm or too cold.
There is a fault in the
vacuum shredder.
The vacuum shredder
is too hot.
There is a fault in the
battery.
No electrical contact
between the vacuum
shredder and the bat‐
tery.
The vacuum shredder
or battery is damp.
The vacuum shredder
is too hot.
There is an electrical
fault.
The vacuum shredder
is clogged.
The catcher bag is full
or dirty.
The suction tube or
blower wheel is clog‐
ged.
The battery is not fully
charged.
The battery service
life has been excee‐
ded.
The battery is too
warm or too cold.
Remedy
► Charge the battery.
► Remove the battery.
► Allow the battery to cool down or warm
up.
► Remove the battery.
► Clean electrical contacts in the battery
compartment.
► Insert battery.
► Switch the vacuum shredder on.
► If 3 LEDs continue to flash red: Do not
use the blower and contact your STIHL
dealer for assistance.
► Remove the battery.
► Wait for the vacuum shredder to cool
down.
► Remove battery and reinsert it.
► Switch the vacuum shredder on.
► If 4 LEDs continue to flash red: Do not
use the battery; contact a STIHL authori‐
zed dealer.
► Remove the battery.
► Clean electrical contacts in the battery
compartment.
► Insert battery.
► Allow the vacuum shredder or battery to
dry, 20.4..
► Remove the battery.
► Wait for the vacuum shredder to cool
down.
► Remove battery and reinsert it.
► Switch the vacuum shredder on.
► Remove the battery.
► Clean the vacuum shredder.
► Remove the battery.
► Empty the catcher bag.
► Clean the catcher bag.
► Remove the battery.
► Clean the vacuum shredder.
► Fully charge the battery.
► Replace battery.
► Leave battery inserted in charger.
Charging starts automatically as soon as
the permitted temperature range is rea‐
ched.
19 Troubleshooting
0458-828-9621-C