Connecting Charger To Power Supply; Charging The Battery - Stihl BGA 85 Notice D'emploi

Mounting the nozzle
2
3 4
Push the nozzle (1) onto the blower
N
tube (2) – the lug (3) must engage
the groove (4).
Lock the nozzle (1) by rotating it in
N
the direction of the arrow as far as
the stop.
Remove the nozzle in the reverse
sequence.
BGA 85
Connecting Charger to
Power Supply
Power supply (mains) voltage and
1
operating voltage must be the same.
Insert the plug (1) in the wall
N
outlet (2).
A self test is performed after the charger
is connected to the power supply. During
this process, the light emitting diode (1)
on the charger lights up green for about
1 second, then red and goes off again.
2
1
1

Charging the Battery

A factory-new battery is not fully
charged.
Recommendation: Fully charge the
battery before using it for the first time.
Connect the charger to the power
N
supply – mains voltage and
operating voltage of the charger
must be the same – see
"Connecting Charger to Power
Supply".
Operate the charger only in enclosed
and dry rooms at ambient temperatures
between +5°C to +40°C (+41°F to
+104°F)
Only charge dry batteries. Allow a damp
battery to dry before charging.
Push the battery (1) into the
N
charger (2) until noticeable
resistance is felt – then push it as far
as stop.
English
2
7