Leds On The Battery; Assembling The Vacuum Shredder; Attaching The Nozzle - Stihl SHA 56 Notice D'emploi

English
► Press the button (1).
The LEDs (5) glow green for about 5 seconds
and indicate the state of charge.
► If the LED on the right flashes green: Charge
the battery.
6.3

LEDs on the battery

The LEDs can indicate the state of charge of the
battery or any faults. The LEDs can be steady
green, steady red or flashing.
If the LEDs are steady or flashing green, this
indicates the state of charge of the battery.
► If the LEDs glow or flash red: Troubleshooting,
19.1.
There is a malfunction in the vacuum shredder
or battery.
7 Assembling the Vacuum
Shredder
7.1

Attaching the Nozzle

2
3
► Pull the blower tube (3) out of the suction tube
(2).
► Pull the nozzle (4) out of the nozzle (1).
2
3
4
► Line up the hole (4) and the lug (5).
The arrows (3) point to each other.
► Push the nozzle (1) onto the suction tube (2).
The nozzle (1) engages audibly and no longer
needs to be removed.
26
1
4
1
5
3

7 Assembling the Vacuum Shredder

7.2 Attaching and Removing the
Suction Tube
7.2.1 Attaching the Suction Tube
► Switch off the vacuum shredder and remove
the battery
2
► Pull the retaining latch (1).
► Fully open the shield (2).
3
4
► Insert the suction tube (3) into the blower
housing (4).
► Swivel the suction tube into the blower hous‐
ing.
The suction tube (3) engages with an audible
click.
7.2.2 Removing the Suction Tube
► Switch off the vacuum shredder and remove
the battery.
► Hold the suction tube and pull the retaining
latch.
► Remove the suction tube from the blower
housing.
► Close the shield.
The retaining latch engages with an audible click.
7.3 Attaching and Removing the
Catcher Bag
7.3.1 Attaching the Catcher Bag
► Switch off the vacuum shredder and remove
the battery.
► Close the zip on the catcher bag.
1
0458-828-9621-C